Multitech V.90/K56FLEX MT5600ZDXV - Manual (Page 62)

62
Models MT5600ZDX & ZDXV
Result Codes
When the modem receives an AT command from the terminal or PC, it tries
to execute the command, then sends a status message to the PC or
terminal reporting the "results" of the command (hence the name "result
codes"). In the Modem Command mode, several visual responses, or
“Result Codes”, may appear on your PC's video monitor.
Note that Extended Result Codes are displayed when your modem is set
up to do so with an X1, X2, X3, or X4 command; these Extended Result
Codes are denoted with an asterisk (*) in the table below.
Table 3-4 Result Codes
Terse Verbose Description
0 OK Command executed
1 CONNECT Modem connected to line
2 RING Ring signal detected
3 NO CARRIER Carrier signal lost or not detected
4 ERROR Invalid command
5 * CONNECT 1200 Connected at 1200 bps
6 NO DIALTONE No dial tone detected
7 BUSY Busy signal detected
8 NO ANSWER No answer at remote end
10 * CONNECT 2400 Connected at 2400 bps
11 * CONNECT 4800 Connected at 4800 bps
12 * CONNECT 9600 Connected at 9600 bps
13 * CONNECT 7200 Connected at 7200 bps
14 * CONNECT 12000 Connected at 12000 bps
15 * CONNECT 14400 Connected at 14400 bps
16 * CONNECT 19200 Connected at 19200 bps
17 * CONNECT 38400 Connected at 38400 bps