Muratec MFX-1950 - Manual (Page 10)

ii
Regulatory information
Customer information
United States of America
The MFX-1950/F-315 hereafter referred to as “product”, complies with Part 68 of the
FCC rules and the requirements adopted by the ACTA. On the rear panel of the product
is a label that contains, among other information, a product identifier in the format US:
DKUFA23B004C (for MFX-1950/F-315). If required, this number must be provided to
the telephone company.
The REN is used to determine the number of devices that may be connected to a tele-
phone line. Excessive RENs on a telephone line may result in the devices not ringing
in response to an incoming call. In most, but not all areas, the sum of RENs should not
exceed five (5.0). To be certain of the number of devices that may be connected to a line,
as determined by the total RENs, contact the local telephone company. The REN for this
product is part of the product identifier that has the format US:DKUFA23B004C (for
MFX-1950/F-315). The digits represented by “23B” are the REN without a decimal point.
The product is designed for use on standard-device telephone lines. The product con-
nects to the telephone line with a standard line called the USOC RJ-11C.
Any plug and jack used to connect the product to the wiring and telephone network of
the premises must comply with the applicable Part 68 of the FCC rules and the require-
ments adopted by the ACTA. A compliant telephone cord and modular plug is provided
with this product. It is designed to be connected to a compatible modular jack that is
also compliant. See installation instructions for details.
If the product causes harm to the telephone network, the telephone company will notify
you in advance that temporary discontinuance of service may be required. If advance
notice isn’t practical, the telephone company will notify you as soon as possible and may
advise you of your right to file a complaint with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operations or
procedures that could affect the operation of the product. If this happens, the telephone
company will provide advance notice in order for you to make necessary modifications to
maintain uninterrupted service.
If trouble is experienced with the product, see operating instructions for details. For
further repair or warranty information, please contact the Muratec Customer Support
Center at 800-347-3296 (from the U.S. A. only). If the product is causing harm to the
telephone network, the telephone company may request that you disconnect the product
until the problem is resolved.
Connection to party line service is subject to state tariffs. Contact the state public utility
commission, public service commission, or corporation commission for information.
If your home has specially wired alarm equipment connected to the telephone line,
ensure the installation of the product does not disable your alarm equipment. If you
have questions about what will disable alarm equipment, consult your telephone com-
pany or a qualified installer.
The product is hearing aid compatible.
When programming emergency numbers and/or making test calls to emergency num-
bers:
1) Remain on the line and briefly explain to the dispatcher the reason for the call.
2) Perform such activities in the off-peak hours, such as early morning or late evenings.