Magellan GPS Tracker - Manual (Page 34)

24 Magellan GPS Tracker
Setting Track History
Using TRACK HISTORY records where you have been by automatically
storing locations, as “dropping bread crumbs” from your starting point as
you travel. This will be especially useful when you want to return to your
starting point, the receiver uses these points to return using the same path to
your starting point.
You can set the distance at which the receiver drops these points by
selecting TRACK HISTORY. You can choose from OFF, AUTO, and a
list of other distance units. If AUTO is chosen, the receiver will
automatically store track history points based on your speed and
direction of travel. Therefore, when travelling a straight distance, fewer
track points will be dropped than when you are turning.
While in the PLOT screen press MENU. Highlight TRACK HIST and
press ENTER. You are presented with a pop-up menu from which you
can make your selection. Use the UP/DOWN ARROWs to highlight
your choice and press ENTER. You will return to the PLOT screen, still
in the customize mode. You can continue to customize the display or
press QUIT to exit.
Clearing the Track
Your screen may become cluttered with your track history. The CLR
TRACK option allows you to clear your track history, i.e., clear your “bread
crumbs”.
While viewing the PLOT screen, press MENU. Highlight CLR
TRACK and press ENTER. Use the UP/DOWN ARROWs to select
YES or NO and press ENTER. You are returned to the PLOT screen.
Setting Up the Plotter
This menu allows you to change the orientation, to turn the waypoint names
on or off, to turn the plot rings on or off, set the course projection and turn
multiple routes on or off.
Setting Plotter Orientation. Under Plotter Orientation, you have three
choices TRACK UP (direction you are moving is at the top of the