IBM 704 User Manual
Page 137
Installing Memory-Module Kits
5. Touch the static-protective package to any unpainted metal
surface on the server. Then, remove the memory-module kit
from the package.
Stat
ic
Devices
6. Install the kit:
a. Start with the lowest-numbered sockets in bank 1.
b. Turn the memory module so that the notched end 1 is on
the left, and the top faces away from you.
c. Insert the SIMM into the memory-board connector,
downward at a 45-degree angle.
d. Press the SIMM firmly into the socket 2 , until it is grasped
by the retaining clips 3 . Verify that the SIMM has been
installed correctly. If the SIMM remains at an angle, it has
been installed correctly. If a gap exists between the SIMM
and the clips, the SIMM has not been properly installed. In
this case, open the clips and remove the SIMM; then,
reinsert the SIMM.
1
2
3
Chapter 4. Installing Options
119