IBM 704 - Manual (Page 51)

To install OS/2 LAN Server 4.0, do the following steps:
1. Run the MPTS utility program with LAN Server 4.0 or OS/2
Requester 4.0.
Note:
MPTS = Multiple Protocol Transport Services
LAPS = LAN Adapter Protocol Support
2. Click Install.
3. When you are prompted, insert the network-adapter
configuration diskette in drive A and click OK.
4. When Install reads the network adapter disk, installation is
complete. Click OK. The adapter driver has been copied to
your server.
5. Click Configure from the MPTS window.
6. At the Configure window, make sure the LAN adapters and
protocols button is highlighted, and click CONFIGURE.
7. At the LAPS Configuration window, select the appropriate
network adapter from the Network Adapters windows.
8. Click Add in the Network Adapter window to add the network
adapter to the current configuration.
9. Select your desired Protocols from the Protocol window. Click
Add from this window to add the protocols to the current
configuration.
10. Click OK when you are done and follow the prompts to exit
MPTS. Your CONFIG.SYS file is automatically updated.
11. Shutdown and reset your server so that the changes you have
made can take affect.
After you install OS/2 LAN Server 4.0, install the Fixpaks that were
described at the beginning of this section; then, review “Device
Drivers” on page 36 and “Installation Checklist” on page 37.
Chapter 2. Installing Your Software 33