Integra DTR-5.5 - Manual (Page 12)

12
Front & Rear Panels —Continued
J OPTICAL DIGITAL (27, 28, 30, 32, 34, 35)
The DTR-5.5 doesn’t have an IN 4 jack.
The optical digital audio inputs can be used to con-
nect CD and DVD players, and other components
with an optical digital audio output.
The optical output can be used to connect a CD
recorder or other digital recorder with an optical
digital input.
K COAXIAL DIGITAL (27, 28, 30, 32, 34, 35)
The coaxial digital audio inputs can be used to con-
nect CD and DVD players, and other components
with a coaxial digital audio output.
The coaxial output can be used to connect a CD
recorder or other digital recorder with a coaxial dig-
ital input.
The DTR-5.5 do not have a coaxial output.
L ZONE 2 SPEAKERS (74)
These terminal posts are for connecting speakers in
Zone 2.
M FRONT, CENTER, SURROUND &
SURROUND BACK SPEAKERS (23)
These terminal posts are for connecting your front,
center, surround, and surround back speakers.
N AC OUTLETS (38)
These switched AC outlets can be used to supply
power to other AV components. The type of outlet
depends on the country in which you purchased
your AV receiver. Some models have a single outlet.
O Grounding screw (DTR-6.5 only) (36)
This screw is for connecting a turntable’s ground
wire.
P PHONO IN (DTR-6.5 only) (36)
This analog input is for connecting a turntable.
Q CD IN (34)
This analog audio input is for connecting a CD
player’s analog audio output.
R TAPE IN/OUT (34)
This analog audio input and output are for connect-
ing a recorder with an analog audio input and output
(cassette, Mini Disc, etc).
S VIDEO 3 IN (27, 31)
Here you can connect a video source (VCR, set-top
box, etc). Input jacks include S-Video, composite
video, and analog audio.
T VIDEO 2 IN/OUT (30, 31)
Here you can connect a VCR. Input and output
jacks include S-Video, composite video, and analog
audio.
U VIDEO 1 IN/OUT (30, 31)
Here you can connect a VCR. Input and output
jacks include S-Video, composite video, and analog
audio.
V DVD IN (28, 29)
Here you can connect a DVD player. Input jacks
include S-Video, composite video, and analog
audio. You can connect a DVD player’s 2-channel
analog audio output or 5.1-channel analog audio
output.
W ZONE 2 OUT (74)
This analog audio output can be connected to a line
input on an integrated amplifier in Zone 2.
The DTR-6.5 also has a ZONE 2 OUT SUB-
WOOFER jack that can be used to feed a subwoofer
in Zone 2.
These jacks can can be configured as either line outs
or pre outs on the onscreen setup menus.
X REMOTE CONTROL (37)
This (Remote Interactive) jack can be con-
nected to an jack on another Integra AV compo-
nent. The AV receiver’s remote controller can then
be used to control that component. To use
, you
must make an analog audio connection (RCA)
between the AV receiver and the other AV compo-
nent, even if they are connected digitally.
Y PRE OUT (37)
These analog audio outputs are for connecting a
separate power amplifier. Useful if you want to con-
nect a more powerful amplifier and use the AV
receiver as a preamp. The SUBWOOFER jack is for
connecting a powered subwoofer.
Z AC INLET (38)
The supplied power cord should be connected here.