Integra DTR-5.5 - Manual (Page 44)

44
First Time Setup —Continued
Minimum Speaker Impedance
(not American models)
If the impedance of any of the connected speakers is 4
ohms or more, but less than 6 ohms, set the Minimum
Speaker Impedance to “4 ohms.”
Note:
Before you change this setting, turn down the volume.
Notes:
• This procedure can also be performed on the AV
receiver by using its [Setup] button, arrow buttons, and
[Enter] button.
1 Press the [Receiver] button fol-
lowed by the [Setup] button.
The main menu appears onscreen.
This setting is not set automatically by the Automatic
Speaker Setup function (see page 39).
Pure A
On Standby
T V
Display Muting
Random Rec
Last Memory Angle Subtitle Audio
Memory Search A-B Repeat
RC- 585M
Exit
Gu id e
Prev
CH
T V CH
TV VOL
--/---
Dimmer
Tape
TV
Input
Sleep
Input I
Enter
Test Tone CH SEL
Surround THX
Direct
Stereo All ST
Level+ Level-
L Night
DSP DSP
To p M enu Men
u
Set up
Retu
rn
VOL CH
Disc
SAT T V VCR Cable
DVD Receiver C D
+10 0 Clear
1 2 3
4 5 6
7 8 9
+
-
Video Off Open/Close
Macro
1 2 3
MD/CDR
Re-EQ
+
-
Input Selector
V 1 V 2 V 3
C D
Phono
Tape
V 4 DVD Multi CH
Tuner
Remote Mode
Zone 2
2–4
1, 5
2, 3
1
Receiver
2 Use the Up and Down [ ]/[ ]
buttons to select “1. Initial
Setup,” and then press [Enter].
The Initial Setup menu appears.
3 Use the Up and Down [ ]/[ ]
buttons to select “3. Hardware
Setup,” and then press [Enter].
The Hardware Setup menu appears.
(Menus vary depending on country.)
4 Use the Up and Down [ ]/[ ]
buttons to select “b. Sp Imped-
ance Minimum,” and then use the
Left and Right [
]/[ ] buttons to
select:
4 ohms: Select if the impedance of any
connected speaker is 4 ohms
or more, but less than 6 ohms.
6 ohms: Select if the impedances of all
connected speakers are
between 6 and 16 ohms.
5 Press the [Setup] button.
The setup menu closes.
Enter
Enter
Enter
Enter
Menu
------------------------
1.Initial Setup
2.Speaker Setup
Advanced Setup
3.Surround Setup
4.Audio Adjust
5.Listening Mode Preset
6.Preference
Basic Setup
1.Initial Setup
------------------------
2.Component Video
3.Hardware Setup
1.Digital Input 1-3.Hardware Setup
------------------------
:Not Activated
b.Zone2 Out
:Fixed
c.Sp Impedance Minimum
:6ohms
d.TV Format :AUTO
a.Powered Zone2
Enter