Integra DTR-5.5 - Manual (Page 76)

76
Zone 2 —Continued
The ZONE 2 OUT L/R jacks can also be used as pre
outs.
Setting the Zone 2 Out
1 Press the [Receiver] button fol-
lowed by the [Setup] button.
The main menu appears onscreen.
2 Use the Up and Down [ ]/[ ]
buttons to select “1. Initial
Setup,” and then press [Enter].
The Initial Setup menu appears.
Pure A
Display Muting
Random Rec
Last Memory Angle Subtitle Audio
Memory Search A-B Repeat
Exit
Gu id e
Prev
CH
TV VOL
--/---
Dimmer
Tape
TV
Input
Sleep
Enter
Test Tone CH SEL
Surround THX
Direct
Stereo All ST
Level+ Level-
L Ni ht
DSP DSP
To p M enu Men
u
Set up Retu
rn
VOL CH
Disc
SAT T V VCR Cable
DVD Receiver C D
+10 0 Clear
7 8 9
Video Off Open/Close
Macro
1 2 3
MD/CDR
Re EQ
+
-
Input Selector
Phono
Remote Mode
Zone 2
2–4
2, 3
1, 5
1
Receiver
Enter
Enter
3 Use the Up and Down [ ]/[ ]
buttons to select “3. Hardware
Setup,” and then press [Enter].
The Hardware Setup menu appears.
4 Use the Up and Down [ ]/[ ]
buttons to select “b. Zone 2 Out,”
and use the Left and Right [
]/
[ ] buttons to select:
Fixed: The ZONE 2 OUT L/R jacks
work as line outs, and you can control
the volume solely on the connected
amplifier.
Variable: The ZONE 2 OUT L/R jacks
work as pre outs. Since the output level
is controlled by the AV receiver’s Mas-
ter Volume control, you cannot control
the volume solely on the connected
amplifier.
5 Press the [Setup] button.
The setup menu closes.
Enter
Enter
Menu
------------------------
1.Initial Setup
2.Speaker Setup
Advanced Setup
3.Surround Setup
4.Audio Adjust
5.Listening Mode Preset
6.Preference
Basic Setup
1.Initial Setup
------------------------
2.Component Video
3.Hardware Setup
1.Digital Input 1-3.Hardware Setup
------------------------
:Not Activated
b.Zone2 Out
:Fixed
a.Powered Zone2
Enter
Menu
------------------------
1.Initial Setup
2.Speaker Setup
Advanced Setup
3.Surround Setup
4.Audio Adjust
5.Listening Mode Preset
6.Preference
Basic Setup
1.Initial Setup
------------------------
2.Component Video
3.Hardware Setup
1.Digital Input 1-3.Hardware Setup
------------------------
:Not Activated
b.Zone2 Out
:Fixed
c.Sp Impedance Minimum
:6ohms
d.TV Format :AUTO
a.Powered Zone2