Integra DTR-5.5 - Manual (Page 42)

42
First Time Setup —Continued
Digital Input
If you connect a component to a digital input jack, you
must assign that jack to an input selector. For example, if
you connect your CD player to the OPTICAL IN2 jack,
you should assign that jack to the CD input selector. By
default, the OPTICAL IN1 jack is assigned to the DVD
input selector, although this can be changed.
Note:
• This procedure can also be performed on the AV
receiver by using its [Setup] button, arrow buttons, and
[Enter] button.
Initial Setup
1 Press the [Receiver] button fol-
lowed by the [Setup] button.
The main menu appears onscreen.
2 Use the Up and Down [ ]/[ ]
buttons to select “1. Initial
Setup,” and then press [Enter].
The Initial Setup menu appears.
Pure A
Display Muting
Random Rec
Last Memory Angle Subtitle Audio
Memory Search A-B Repeat
Exit
Gu id e
Prev
CH
TV VOL
--/---
Dimmer
Tape
TV
Input
Sleep
Enter
Test Tone CH SEL
Surround THX
Direct
Stereo All ST
Level+ Level-
DSP DSP
To p M enu Men u
Set up
Retu
rn
VOL CH
Disc
SAT T V VCR Cable
DVD Receiver C D
+10 0 Clear
7 8 9
Video Off Open/Close
Macro
1 2 3
MD/CDR
+
-
Input Selector
C D
Phono
Tape Tuner
Remote Mode
Zone 2
2–4
2, 3
1, 5
1
Receiver
Enter
Enter
3 Use the Up and Down [ ]/[ ]
buttons to select “1. Digital
Input,” and then press [Enter].
The Digital Input menu appears.
• There are no assignments for
TUNER.
• VIDEO 4 is assigned to the optical
digital input on the front panel and
cannot be changed.
4 Use the Up and Down [ ]/[ ]
buttons to select an input selec-
tor, and then use the Left and
Right [
]/[ ] buttons to select a
digital input jack.
Examples:
If you connect your DVD player to the
OPTICAL IN 2 jack, set “a. DVD” to
“OPT2.”
If you want to listen to audio from the
component connected to the OPTICAL
IN 3 jack when the VIDEO 1 input
selector is selected, set “b. VIDEO1” to
“OPT3.”
If you want to listen to audio from the
component connected to the COAX-
IAL IN 1 jack when the VIDEO 2 input
selector is selected, set “c. VIDEO2” to
“COAX1.”
For input selectors that you don’t want
to assign a digital input jack, leave them
set to “-----.”
5 Press the [Setup] button.
The setup menu closes.
Enter
Enter
Menu
------------------------
1.Initial Setup
2.Speaker Setup
Advanced Setup
3.Surround Setup
4.Audio Adjust
5.Listening Mode Preset
6.Preference
Basic Setup
1.Initial Setup
------------------------
2.Component Video
3.Hardware Setup
1.Digital Input 1-1.Digital Input
a.DVD :OPT1
------------------------
b.VIDEO1 :-----
c.VIDEO2 :-----
d.VIDEO3 :-----
e.TAPE :-----
f.CD :-----
g.PHONO :-----
Enter