Integra DTR-5.5 - Manual (Page 54)

54
Basic Operation —Continued
You can adjust the brightness of the display.
You can temporarily mute the output of the AV receiver.
With the sleep timer, you can set the AV receiver to auto-
matically turn off after a specified period.
If you need to cancel the sleep timer, press the [Sleep]
button repeatedly until the SLEEP indicator disappears.
To check the time remaining until the AV receiver sleeps,
press the [Sleep] button. Note that if you press the
[Sleep] button while the sleep time is being displayed,
you’ll shorten the sleep time by 10 minutes.
You can connect a pair of stereo headphones (1/4-inch
phone plug) to the AV receiver’s Phones jack for private
listening, as shown.
Notes:
• Always turn down the volume before connecting your
headphones.
• The speakers are turned off while the headphones plug
is inserted in the Phones jack. (Zone 2 speakers are not
turned off.)
• When you connect a pair of headphones, the listening
mode is set to Stereo, unless it’s already set to Stereo,
Mono, Direct, or Pure Audio. When you disconnect
the headphones, the previous listening mode is
resumed.
• Only the Stereo, Direct, Pure Audio, and Mono listen-
ing modes can be used with headphones. (The listen-
ing modes available also depends on the currently
selected input source.)
• When the multichannel input is used, only the front
left and right audio can be heard in the headphones.
On the DTR-6.5, when the Stereo or Mono listening
mode is selected, audio is downmixed for a good
sound.
Setting the Display Brightness
Press the [Receiver] button, and
then press the [Dimmer] button
repeatedly to select Normal, Dim
or Dimmer.
• Normal
• Dim
• Dimmer
Muting the AV receiver
Press the [Receiver] button, and
then press the [Muting] button.
The output is muted and the MUTING
indicator flashes on the display, as
shown.
To unmute the AV receiver, press the
[Muting] button again, or adjust the
volume.
The Mute function is cancelled when
the AV receiver is set to Standby.
Display Muting
Random Rec
Exit
Gu id e
Prev
CH
TV VOL
--/---
Dimmer
Tape
TV
Input
Sleep
Enter
To p M enu Men u
Set up
Retu
rn
VOL CH
Disc
SAT T V VCR Cable
DVD Receiver C D
+10 0 Clear
7 8 9
Macro
1 2 3
MD/CDR
+
-
Input Selector
C D
Phono
Tape Tuner
Remote Mode
Zone 2
Dimmer Sleep
Muting
Press
[Receiver]
first
Receiver
Dimmer
Receiver
Muting
Using the Sleep Timer
Press the [Receiver] button, and
then press the [Sleep] button
repeatedly to select the required
sleep time.
The sleep time can be set from 90 to 10
minutes in 10 minute steps.
The SLEEP indicator appears on the
display when the sleep timer has been
set, as shown. The specified sleep time
appears on the display for about five
seconds, then the previous display
reappears.
Using Headphones
Receiver
Sleep
Standby
Zone 2
Phones