Integra DTR-5.5 - Manual (Page 9)

9
Front & Rear Panels —Continued
For detailed information, see the pages in parentheses.
A Standby/On button (38)
This button is used to set the AV receiver to On or
Standby. For models with a POWER switch, this
button has no effect unless the POWER switch is set
to ON.
B Standby indicator (38)
This indicator lights up when the AV receiver is in
Standby mode, and it flashes while a signal is being
received from the remote controller.
C Zone 2 indicator (77)
This indicator lights up when Zone 2 is selected.
D Remote-control sensor (13)
This sensor receives control signals from the remote
controller.
E Rec Out button (64)
This button is used to select the input source to be
recorded.
F Zone 2 button (77)
This button is used to select the input source for
Zone 2.
G Level button (77)
This button is used to set the volume for Zone 2.
H Tone button (78)
This button is used to adjust the bass and treble for
Zone 2.
I Controller [ ] [ ] buttons (64, 77, 78)
These buttons are used to select the input source to
be recorded via the REC OUTs, to select the input
source for Zone 2, and to set the volume, bass, and
treble for Zone 2.
J Stereo button (58)
This button is used to select the Stereo listening
mode.
K Listening Mode [ ] [ ] buttons (58)
These buttons are used to select the listening modes.
L Display button (55)
This button is used to display various information
about the currently selected input source.
M Display
See “Display” on page 10.
N Memory button (57)
This button is used when storing or deleting radio
presets.
O Tuning Mode button (56)
This button is used to select the Auto or Manual tun-
ing mode.
P Dimmer button (54)
This button is used to adjust the display brightness.
Q Setup button (42)
This button is used to access the onscreen setup
menus that appear on the connected TV.
R Arrow/Tuning/Preset & Enter buttons (42)
When the AM or FM input source is selected, the
Tuning [
] [ ] buttons are used to tune the tuner,
and the Preset [ ] [ ] buttons are used to select
radio presets (see page 57). When the onscreen
setup menus are used, they work as arrow buttons
and are used to select and set items. The Enter but-
ton is also used with the onscreen setup menus.
S Return button
This button is used to return to the previously dis-
played onscreen setup menu.
T Master Volume control (53)
This control is used to adjust the volume of the AV
receiver to MIN, 1 through 99, or MAX
U Pure Audio indicator (58)
This indicator lights up when the Pure Audio listen-
ing mode is selected.
V Phones jack (54)
This 1/4-inch phone jack is for connecting a stan-
dard pair of stereo headphones for private listening.
W Setup Mic (39)
The included speaker setup microphone is con-
nected here for automatic speaker setup.
X Tone, [–] & [+] buttons (78)
These buttons are used to adjust the bass and treble.
Y Input selector buttons (53)
These buttons are used to select from the following
input sources: Multi CH, DVD, VIDEO 1,
VIDEO 2, VIDEO 3, VIDEO 4, TAPE, TUNER,
CD, or PHONO (DTR-6.5 only).
The [Multi CH] button selects the DVD analog mul-
tichannel input.
Z Video 4 Input (33, 65)
This input can be used to connect a camcorder,
games console, and so on. There are jacks for opti-
cal digital audio, S-Video, composite video, and
analog audio.