IBM 09-0572-000 - Manual (Page 28)

3
U
SING THE
A
UTO
L
INK
F
EATURE FOR
N
ET
W
ARE
The AutoLink auto installation feature for NetWare configures
the adapter as a NetWare DOS ODI client. The AutoLink
installation steps are depicted in Figure 3-1.
Figure 3-1 AutoLink Installation Process
This chapter describes the AutoLink program requirements,
ways to avoid memory conflicts, and installation steps. See
Chapter 5 for other NetWare and NDIS operating system
information and see Chapter 6 for information about installing
the network driver for Windows NT and Windows 95.
The AutoLink program performs the following functions:
■
Configures the 3C619C adapter.
■
Tests the adapter.
■
Installs the DOS ODI client driver.
Insert TokenDisk diskette.
Make diskette drive active.
Remove diskette
and reboot computer
Type: AUTOLINK
Select ring speed and
configuration mode
If memory manager is installed,
exclude memory range
D8000 – DBFFF