IBM 09-0572-000 - Manual (Page 87)

Messages C-5
Unable to locate an unused shared RAM base address. Try the
following: 1. Boot the PC with no drivers or TSR’s loaded. 2. If a
Memory Manager is loaded, exclude from it the memory
segment to be assigned to the 3C619C adapters.
Unable to recognize value xxxx at line xxxx in the
configuration file. Please change to a valid setting. A list of
valid settings is provided in the INSTRUCT.TXT file in the
\DIAG subdirectory of this diskette.
Unable to recognize value xxxx on the command line. Please
change to a valid setting. Valid settings are described in the
INSTRUCT.TXT file in the \DIAG subdirectory of this diskette.
Unable to recognize variable xxxx at line xxxx in the
configuration file. Please change to a supported variable. A list
of supported variables is provided in the INSTRUCT.TXT file in
the \DIAG subdirectory of this diskette.
You are about to exit, but your new adapter configuration
has not been saved. Do you want to exit without saving?
You must enable the Open Adapter Test and the Close Adapter
Test simultaneously. Neither test can be run independently.