IBM 09-0572-000 - Manual (Page 84)

C-2 A PPENDIX C: E RROR M ESSAGES
An adapter was configured from EISA to ISA mode, but the
EISA configuration utility has not run yet. Place your EISA
configuration diskette in drive A, and reboot the PC.
An EISA configured adapter is installed in an ISA PC. Use the
Configure Adapter option to reconfigure the I/O Base Address
to an ISA setting (A20, A24, 200–2E0, or 300–3E0).
Attempting to configure the I/O Base Address to EISA mode.
This is not allowed in an ISA PC. Choose another I/O Base
Address (A20, A24, 200–2E0, or 300–3E0).
Invalid EISA system configuration. Exit the Configuration and
Diagnostic Program and run your EISA configuration utility
again.
The adapter is being configured for EISA mode at line xxxx
in the configuration file. This is not allowed on an ISA PC.
Change the I/O Base Address to an ISA value (A20, A24,
200–2E0, or 300–3E0).
The adapter is in EISA mode. This option can only be set using
the EISA configuration utility. To reconfigure this option, exit
this program, place your EISA configuration diskette in drive A,
and reboot the PC.
The adapter was changed from EISA to ISA mode. Exit this
program, place your EISA configuration diskette in drive A,
and reboot the PC.
The adapter was changed from ISA to EISA mode. Exit this
program, place your EISA configuration diskette in drive A,
and reboot the PC.
The adapter was changed from ISA to EISA mode or from
EISA to ISA mode. Exit this program, place your EISA
configuration diskette in drive A, and reboot the PC.