Intelligent Motion Systems UDAS-1001E - Manual (Page 23)

Configuration and Installation
2-4
Channels connected to a thermocouple must be connected to bias resistors for proper operation.
Use jumpers JP2 and JP3
.
To select the jumpers for each channel that you plan to use for thermocouples, use TABLE 2.1,
CJC Jumper Positions shown below.
TABLE 2.1 CJC Jumper Positions
Note:
When monitoring thermocouples, always use differential channels.
Differential JP1 Jumper Position JP2 Jumper Position
Channel #
1 AI 1 AI 9
2 AI 2 AI 10
3 AI 3 AI 11
4 AI 4 AI 12
5 AI 5 AI 13
6 AI 6 AI 14
7 AI 7 AI 15