Invacare LYNX LX-3PLUS EU - Manual (Page 16)

Invacare Scooters 16 Part No. 1090132 Rev F
PROCEDURE 2 SAFETY INSPECTION/MAINTENANCE
SAFETY
INSPECTION/
MAINTENANCE
ITEM INITIALLY INSPECT/ADJUST
WEEKLY MONTHLY PERIODICALLY
TIRES (PROCEDURE 9)
Inspect for flat spots and wear. X X
If pneumatic tires check for proper inflation. X X
CAUTION: As with any vehicle, the
wheels and tires should be checked
periodically for cracks and wear, and should
be replaced.
CLEANING
Clean upholstery and armrests. X
Clean molded frame. X
FRONT AND REAR SHOCKS -
PANTHER MX-4 ONLY
Bolts are tight. X X
CLEANING X X
HEADLIGHTS (where applicable)
Inspect headlight bulbs for proper operation. X X
MAINTENANCE
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure
that all attaching hardware is tightened securely - otherwise, injury or
damage may occur.
CAUTION
DO NOT over-tighten hardware attaching to the frame. This could cause
damage to the frame.
SUGGESTED MAINTENANCE PROCEDURES
1. Before using the powered scooter, make sure all nuts and bolts are tight. Check any
parts for damage or wear and replace. Check all parts for proper adjustment.
2. Ensure that batteries are properly maintained and charged as required (PROCEDURE 4).
3. Inspect brake for proper operation (PROCEDURE 3).
4. The wheels and tires should be checked periodically for cracks and wear, and should
be replaced by a qualified technician.
5. Regularly check for loose nuts and/or bolts in the front and rear wheels. If loose,
have them adjusted by a qualified technician (PROCEDURE 9).
6. Clean dirt, dust and grease from exposed components.
7. Periodically have the bearings of the front wheel checked to make sure they are
clean and free from moisture.