Invacare LYNX LX-3PLUS EU - Manual (Page 35)

Part No. 1090132 Rev F 35 Invacare Scooters
PROCEDURE 5 SEAT
SEAT
NOTE: When installing the seat height adjustment pin, it is necessary to support the weight of
the seat assembly.
C. For adjustable seat seat post ZOOM-3 - install seat assembly onto seat post
with the seat in the forward position.
4. Reinstall stability knob. Hand tighten.
ADJUSTING THE SEAT HEIGHT
1. Determine seat post type. Refer to DETERMINING SEAT POST TYPE in this procedure
of the manual.
2. Perform one (1) of the following:
A. For solid seat posts proceed to SOILD SEAT POSTS in this procedure of the
manual.
B. For adjustable height seat posts proceed to ADJUSTABLE SEAT POSTS in
this procedure of the manual.
WARNING
DO NOT use the stability knob to adjust the seat height. It is NOT designed
to support weight of the user. Otherwise, injury to the user and/or damage
to the scooter may result.
SOLID SEAT POST (FIGURE 3)
1. Remove the seat. Refer to REMOVING/INSTALLING THE SEAT in this procedure
of the manual.
2. Remove the rear shroud. Refer to REMOVING/INSTALLING THE REAR SHROUD
in PROCEDURE 9 of this manual.
3. Remove the batteries w/ cables. Refer to REMOVING/INSTALLING THE
BATTERIES WITH CABLES in PROCEDURE 4 of this manual.
4. If necessary, remove the floor basket. Refer to REMOVING/INSTALLING THE
FLOOR BASKET in PROCEDURE 11 of this manual.
5. Remove the mounting screw and locknut from the frame post.
6. Perform one (1) of the following:
A. For LYNX SX-3, and PAN-
THER MX-4 - Insert mounting
screw into one (3) of the three (3)
height adjustment holes located on
the frame post.
B. For LYNX LX-3, For LYNX
LX-3 Plus and PANTHER LX-4 -
Insert mounting screw into one (1)
of the four (4) height adjustment
holes located on the frame post.
7. Secure mounting screw in place with
EXISTING locknut. Securely tighten.
8. Reassemble scooter by reversing
STEPS 1-4. FIGURE 3 - ADJUSTING THE SEAT
HEIGHT - SOLID SEAT POSTS
Mounting
Screw
Locknut
Height
Adjustment
Holes
Frame Post
Front Frame
Assembly
Stability
Knob
NOTE: Tiller assembly, rear frame assembly,
and front wheel are not shown for clarity.