Intel GD82559ER - Manual (Page 79)

Datasheet 73
Networking Silicon — GD82559ER
10. Electrical and Timing Specifications
10.1 Absolute Maximum Ratings
Maximum ratings are listed below:
Case Temperature under Bias . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0 C to 85 C
Storage Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -65 C to 140 C
Outputs and Supply Voltages (except PCI) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.5 V to 5.0 V
PCI Output Voltages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.50 V to 5.25 V
Transmit Data Output Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.5 V to 8.0 V
Input Voltages (except PCI). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -1.0 V to 5.0 V
PCI Input Voltages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.5 V 6.0 V
Stresses above the listed absolute maximum ratings may cause permanent damage to the 82559ER
device. This is a stress rating only and functional operations of the device at these or any other
conditions above those indicated in the operational sections of this specification is not implied.
Exposure to absolute maximum rating conditions for extended periods may affect device reliability.
10.2 DC Specifications
NOTES:
1. The VIO pin is the a voltage bias pin for the PCI interface. This pin should be connected to 5V ± 5% in a 5 volt
PCI system and 3.3 volts in a 3.3 volt PCI system. Be sure to install a 10K pull-up resistor. This resistor acts
as a current limit resistor in system where the VIO bias voltage maybe shutdown. In this cases the 82559ER
may consume additional current without a resistor.
2. Typical current consumption is in nominal operating conditions (V
CC
= 3.3 V) and average link activity.
Maximum current consumption is in maximum V
CC
and maximum link activity.
The 82559ER supports the PCI interface standards. The 82559ER’s PCI interface is five volts
tolerant and supports both 5 V and 3.3 V signaling environments.
Table 15. General DC Specifications
Symbol Parameter Condition Min Typical Max Units Notes
V
CC
Supply Voltage 3.0 3.3 3.5 V
V
IO
Periphery Clamp
Voltage
PCI 4.75 5.0 5.25 V 1
I
CC
Power Supply 125 195 mA 2
Table 16. PCI Interface DC Specifications
Symbol Parameter Condition Min Max Units Notes
V
IHP
Input High Voltage 0.475V
CC
V
IO
+ 0.5 V
V
ILP
Input Low Voltage -0.5 0.325V
CC
V
V
IPUP
Input Pull-up Voltage 0.7V
CC
V 1
V
IPDP
Input Pull-down Voltage 0.2V
CC
V 1
I
ILP
Input Leakage Current 0 < V
in
< V
CC
±10
µ
A 2