One-touch repeater function, Auto repeater function, M1 spl a/b a=b – Icom I706MKTMG User Manual
Page 35: M4 vox dup ton, Push, Band, Band] to select the 28 mhz band, Rotate [dial] to select the operating frequency, Push [mode] one or more times to select fm, Ton] in the m4 display during repeater operation
32
4
RECEIVE AND TRANSMIT
This function allows you to set repeater operation
with the push of one switch.
➀
Push [
(Y)
BAND]/[
(Z)
BAND] to select the 28 MHz
band.
➁
Rotate [DIAL] to select the operating frequency.
➂
Push [MODE] one or more times to select FM.
➃
Select M4 and turn the one-touch repeater function
ON.
➥ Push and hold [
(F-2)
DUP] to toggle the one-
touch repeater function ON and OFF.
• When the one-touch repeater function is turned ON,
“DUP” (duplex indicator) and “T” (tone frequency
indicator) appear in the display.
• Be sure to set the duplex direction and offset in ini-
tial set mode in advance (p. 52).
• Push [
(F-2)
DUP] to toggle the duplex direction.
☞ NOTE: When you want to transmit a 1750 Hz tone,
while pushing [PTT], push [
(F-3)
TON] in the M4
display during repeater operation.
■ One-touch repeater function
This function automatically activates the repeater set-
tings (DUP+ or DUP– and tone encoder ON/OFF)
when the operating frequency falls within the general
output frequency range and deactivates them when
outside of the range.
Set the auto repeater function ON or OFF in initial set
mode in advance (p. 53). When set ON, repeater set-
tings are automatically activated according to the
table at right.
☞ NOTE: This function is available for the USA ver-
sion only.
■ Auto repeater function
FREQUENCY
DUPLEX DIRECTION
145.200–145.495 MHz
“DUP–” appears
146.610–146.995 MHz
147.000–147.395 MHz
“DUP+” appears
442.000–444.995 MHz
“DUP+” appears
447.000–449.995 MHz
“DUP–” appears
CH
VFO A
P
O
S1
5
5
3
7
9
20
40
10
60dB
FM
BLANK
M1 SPL A/B A=B
CH
VFO A
DUP
P
O
S1
5
5
3
7
9
20
40
10
60dB
FM T
BLANK
M4 VOX DUP TON