Icom I706MKTMG - Manual (Page 37)

34
4
RECEIVE AND TRANSMIT
D CW pitch control
The received CW audio pitch and monitored CW
audio pitch can be adjusted to suit your preferences
(300 to 900 Hz) without changing the operating fre-
quency.
➀
Push [MODE] one or more times to select CW
mode.
➁
Select CW PITCH in quick set mode.
• Push [DISP] for 2 sec. then push [MENU] one or more
times.
➂
Rotate the main dial to set the desired pitch.
➃
Push [DISPLAY] to exit quick set mode.
Q2 CW PITCH
This shows the default
setting for the CW pitch
control (600 Hz). CW
QUICK SET MODE
D CW reverse mode
The CWå (CW Reverse) mode receives CW signals
with a reverse side CW carrier point like that of LSB
and USB modes. Use this mode when interference
signals are near the desired signal and you want to
change the interference tone.
➀
Push [MODE] one or more times to select CW
mode.
➁
Push and hold to toggle between CW and CWå
modes.
• Check the interference tone.
• Receive audio tone response
(Reverse) CWå
MODE
(Normal) CW
BFO
600 Hz
signal
inteference signal
600 Hz
BFO
inteference
D Electronic CW keyer
The IC-706MKIIG has an electronic keyer. Both key-
ing speed and weight (the ratio of dot : space : dash)
can be set in quick set mode.
• Setting the electronic keyer
➀
Select CW mode with [MODE].
➁
Push [DISPLAY] for 2 sec. to enter quick set mode.
➂
Push [MENU] one or more times to select item Q4
CW PADDLE, then rotate the main dial to select
the paddle type.
• When “ud” is selected, the up/down switches on the
microphone can be used as a paddle.
➃
Push [MENU] two more times to select item Q6
RATIO, then rotate the main dial to select the
desired weight.
• Key weight can be selected from 2.8 to 4.5.
• Check the selected ratio with the side tone function in
CW mode.
➄
Push [DISPLAY] momentarily to exit quick set mode.
Paddle operation from front panel MIC connector
Connect a CW paddle as at right to operate an elec-
tronic keyer from the front panel MIC connector.
• This function is available from the front panel mic
connector only.
• Be sure to select item “n,” “r,” “buG” or “oFF” in Q4
CW PADDLE in quick set mode. (p. 49)
• Connect straight key to “DOT” side.
KEYING WEIGHT EXAMPLE: morse code “K”
*SPACE and DOT length can be adjusted with “Q5 KEY
SPEED” only.
DASH
Weight setting:
1:1:3 (default)
Weight setting:
Adjusted
DASH
DOT
(Fixed*)
Adjustable range SPACE (Fixed*)
QUICK SET MODE
front panel
MIC connector
MIC U/D
CW
paddle
DOT
E
DASH
➁
➆
3.9 k Ω ±5%
2.2 k Ω ±5%