Invacare Wheelchair Pronto M91 Base User Manual
Page 39
SECTION 5—WHEELCHAIR OPERATION
39
Pronto® M91™Base with SureStep®
Refer to LCD Display table on page 39 for descriptions of information shown.
LCD DISPLAY
ITEM
DESCRIPTION
DRIVE NAME
This field shows the currently selected Drive’s Name.
Available choices are as follows:
Drive 1*
Drive 2*
Drive 3*
Drive 4*
“No Drive” selected via the programmer.
*NOTE: Drive names can be customized. Actual drive names may display differently.
BATTERY LEVEL
INDICATOR
This symbol shows the Battery Level and will change depending on the available
battery power.
This indicator is shown on every screen.
STATUS MESSAGE
This area displays status or instructions.
STATUS INDICATOR
The status indicator will show a “Warning” (exclamation point inside a triangle)
indicator when the chair has a condition that requires attention.
The status indicator will show a “STOP” sign when a serious condition exists. The
chair will not be allowed to operate.
The status indicator shows an Attendant Icon if the attendant’s override switch is
active.
MODES
The dotted-box shows the area that contains the available “modes” in the cur-
rently selected drive. The modes are programmed for each drive and are based
upon the configuration of the chair.
These modes are highlighted when the Mode is active. The operator changes
modes by pressing the Mode Select Switch.
The available modes are as follows:
Drive Mode (1 through 4)
Automatic Positioning
Actuator Control Switch Mode (4-switch, 4-switch 2 levels, etc.)
ECU Output Activated (1 through 4)
RIM Mode Activated
Drive Select Mode Activated
No Driving