Invacare Wheelchair Pronto M91 Base - Manual (Page 50)

SECTION 7—FOOTBOARD ASSEMBLY
Pronto® M91™Base with SureStep® 50 Part No 1143153
FIGURE 7.1 Removing/Installing the Footboard Assembly
Adjusting the Footboard Assembly
Angle
NOTE: For this procedure, refer to FIGURE 7.2.
1. Loosen the jam nut and set screw located underneath on the back of the footplate.
2. Adjust the set screw in or out to obtain the desired footboard assembly angle.
3. Thread the jam nut and washer inward until it is flush with the footboard bracket.
4. Securely tighten the jam nut and washer to secure the mounting screw in place.
FIGURE 7.2 Adjusting the Footboard Assembly - Angle
DETAIL “A” - BOTTOM
VIEW OF FOOTBOARD
Quick
Release Pin
Outer Edge
of Tube
Detent Balls
Quick
Release
Pin
Wheelchair Frame
Detent
Ball
Footboard
Assembly
Mounting
Hole
Set Screw, Washer
and Jam Nut
Footboard
Assembly