Invacare Wheelchair Pronto M91 Base - Manual (Page 44)

SECTION 5—WHEELCHAIR OPERATION
Pronto® M91™Base with SureStep® 44 Part No 1143153
6. If necessary, perform the following to reposition the adjustment lock:
A. Slide the adjustment lock from the mounting bracket.
B. Rotate adjustment lock 180° and slide adjustment lock over the opposite end of the
mounting bracket.
7. Slide joystick mounting tube through the mounting bracket to the desired position
and secure adjustment lock to tube by turning lever on adjustment lock.
FIGURE 5.11 Repositioning the Joystick - Van Seat
Disconnecting/Connecting the Joysticks
NOTE: For this procedure, refer to FIGURE 5.12.
NOTE: The joystick connector is located at the rear of the seat frame.
SPJ+ Joysticks
Disconnecting
1. Hold the light GREY collar portion of the joystick connector with one hand and the
controller connector on the wheelchair in the other and disconnect them by pulling
them apart.
Connecting
ƽ WARNING
The joystick connector and controller connector fit together in one way only. DO
NOT force them together.
1. Hold the light GREY collar portion of
the joystick connector with one hand
and the controller connector on the
wheelchair in the other and align them.
2. Lightly push to engage the joystick
connector and the controller connector.
FIGURE 5.12 Disconnecting/Connecting
the Joysticks - SPJ+ Joysticks
Hex Mounting Screws
Locknuts
Adjustment Lock Lever
Joystick Mounting
Tube
Mounting
Bracket
Spacers
Arm Frame
NOTE: MK5 SPJ‐80 joystick
shown, all other joysticks
reposition in the same way.
Joystick
Connector
Light Grey Collar
Controller
Connector