Invacare Wheelchair Pronto M91 Base - Manual (Page 51)

SECTION 7—FOOTBOARD ASSEMBLY
Part No 1143153 51 Pronto® M91™Base with SureStep®
Depth
NOTE: For this procedure, refer to FIGURE 7.3.
1. Remove the quick release pin that secures the footboard assembly to the wheelchair
frame.
ƽ WARNING
Make sure the detent balls of the quick release pin are fully released and protruding
past the outer edge of the tube before operating the wheelchair. Otherwise, injury
and/or damage may result.
Keep detent balls clean.
2. Adjust footboard to one of three mounting positions.
3. Install the quick release pin. Make sure the detent balls of the quick release pin are
fully released and past the outer edge of the tube (Detail “A”).
FIGURE 7.3 Adjusting the Footboard Assembly - Depth
DETAIL “A” - BOTTOM
VIEW OF FOOTBOARD
Quick Release Pin
Outer Edge
of Tube
Detent Balls
Quick
Release
Pin
Three
Depth
Adjustment
Holes
Wheelchair Frame
Detent
Ball
Footboard
Assembly
Mounting
Hole