Invacare Compass SPT PH904A - Manual (Page 31)

SECTION 4—FRONT RIGGINGS
Part No 1122134 31 Compass™SPT™
Installing/Removing Lift-Off Footrest
NOTE: For this procedure, refer to FIGURE 4.2.
Installing
1. Insert the footrest assembly mounting
pins into the mounting tube of the
wheelchair frame.
2. Repeat STEP 1 for the other footrest
assembly.
3. If necessary, adjust the footrest height.
Refer to Adjusting Footrest Height on
page 31.
Removing
1. Push the footrest release lever inward
and lift footrest upward.
2. Repeat STEP 1 for opposite side, if
necessary.
FIGURE 4.2 Installing/Removing Lift-Off
Footrest
Adjusting Footrest Height
Height Adjustment Ranges
60°, 70° and 70° Taper
NOTE: For this procedure, refer to FIGURE 4.3 on page 32.
1. Remove the footrest from the wheelchair. Refer to Installing/Removing Swingaway
Front Riggings on page 30.
2. Remove the hex screw and coved spacer and slide the footrest up or down on its
mounting tube until the desired footrest height is achieved.
3. Reassemble the hex screw and coved spacer through the footrest upper support and
mounting tube (FIGURE 4.3).
Footrest Release
Lever
Footrest
Assembly
Mounting Tube
Wheelchair
Frame
Footplate
Mounting Pin
FOOTREST TYPE ADJUSTMENT RANGE
60° 13-17 inches
70° 13-17 inches
90° 5-8 inches
90° 5-11 inches (with 3-inch extension)