Invacare Compass SPT PH904A - Manual (Page 49)

SECTION 6—BACK/SEAT
Part No 1122134 49 Compass™SPT™
Installing/Removing/Adjusting the Adjustable Angle
Stroller Handles
NOTE: For this procedure, refer to FIGURE 6.3.
Installing
1. Remove plug buttons from both back canes.
2. Slide the adjustable height stroller handle into the back canes.
3. Align the mounting holes of the adjustable angle stroller handle and the back cane.
4. Secure adjustable angle stroller handle to the back canes with the two quick-release
pins (Detail “A” of FIGURE 6.3).
5. If necessary, adjust the height.
Removing
1. Press and hold the buttons on the quick-release pins
2. Remove the adjustable angle stroller handle from the back cane.
3. Install plug buttons.
FIGURE 6.3 Installing/Removing/Adjusting the Adjustable Angle Stroller Handles
Stroller Handle
NOTE: Plug buttons not shown for clarity.
Back Cane
Quick-Release Pin
Detent
Ball
Back Cane
Quick-Release Pin
DETAIL “A” - QUICK
RELEASE PIN INSTALLED