Invacare Compass SPT PH904A User Manual
Page 33
SECTION 4—FRONT RIGGINGS
33
3. Remove the hex bolt, coved washers and locknut that secure the lower footrest to the
footrest support.
4. Reposition the lower footrest to the desired height.
5. Reinstall hex bolt, coved washers and
locknut that secure lower footrest to
footrest support. Tighten securely.
6. Repeat STEPS 1-5 for the opposite side
of the wheelchair footrest, if necessary.
7. Reinstall the footrest(s) onto the
wheelchair. Refer to
Installing/Removing Swingaway Front
Riggings on page 30.
8. Reinstall any accessory onto the
footrest(s).
FIGURE 4.5 Adjusting Footrest Height -
Model PHW93 and PH904A Front Riggings
Installing Adjustable Angle Flip-up Footplate Hinge
NOTE: For this procedure, refer to FIGURE 4.6.
1. Position the adjustable angle flip-up
footplate hinge on the footrest support
tube at the desired height.
2. Position the hardware on the footrest
support as shown in FIGURE 4.6.
3. Flip the footplate hinge to the UP
position.
NOTE: The footplate hinge will fall to the
DOWN position.
4. Tighten the socket screw and locknut
that secure the footplate hinge to the
footrest support until the footplate
hinge remains in the up position.
5. Check the up and down motion of the
footplate hinge to make sure the user of
the wheelchair can operate the
footplates easily.
\
FIGURE 4.6 Installing Adjustable Angle
NOTE: If the footplateʹs motion is too tight, loosen the socket screw and locknut approximately
¼-turn.
NOTE: If the footplateʹs motion is too loose, tighten socket screw and locknut approximately
¼-turn.
Footrest
Support
Coved Washer
Hex
Bolt
Lower Footrest
Locknut
Coved Washer
Footrest
Support
Tube
Locknut
Socket
Screw
Footplate
Hinge