Invacare Compass SPT PH904A - Manual (Page 42)

SECTION 5—ARMS
Compass™SPT™ 42 Part No 1122134
2. Replace the existing clothing guard with the new clothing guard and securely tighten
with the existing hardware.
3. Repeat STEPS 1-2 for the opposite side if necessary.
Installing/Removing T-Arms
NOTE: For this procedure, refer to FIGURE 5.3.
Installing T-Arms
1. Position the T-Arm over the T-Arm socket on the wheelchair frame.
NOTE: Make sure the locking lever is towards the front of the wheelchair.
2. Slide T-Arm into T-Arm socket until the locking lever is in the slot in the T-Arm socket
and an audible “click” is heard.
3. Pull up on T-Arm to make sure T-Arm is locked in place.
NOTE: If the T-Arm does not slide in the T-Arm socket as desired, adjust the T-Arm socket. Refer
to Adjusting T-Arm Sockets on page 45.
4. Adjust the T-Arm for desired height, width and depth, if necessary. Refer to Adjusting
The T-Arms on page 43.
5. Repeat STEPS 1-4 for opposite side of wheelchair.
Removing T-Arms
1. Press the locking lever in and lift the
T-Arm straight up and out of the T-Arm
socket.
NOTE: If the T-Arm does not slide up and
down in the T-Arm socket as desired, adjust the
T-Arm socket. Refer to Adjusting T-Arm
Sockets on page 45.
2. Repeat STEP 1 for opposite side of the
wheelchair.
FIGURE 5.3 Installing/Removing T-Arms
T-Arm
Socket
Locking Lever
(towards the front of
the wheelchair)
T-Arm
Wheelchair
Frame
Slot