Invacare Compass SPT PH904A - Manual (Page 35)

SECTION 4—FRONT RIGGINGS
Part No 1122134 35 Compass™SPT™
Composite/Articulating Footplate Heel Loop
Replacement
NOTE: For this procedure, refer to FIGURE 4.8.
Disassembly
Composite.
1. Remove the hex screw and coved
spacer that secure the lower footrest
assembly to the swing away footrest
assembly.
2. Remove the lower footrest assembly.
3. Remove the mounting screw and
locknut that secure the heel loop to the
footrest.
4. Slide heel loop off of the footrest.
Articulating.
1. Remove the mounting screws, washers
and spacers that secure the heel loop to
the articulating footplate.
Reassembly
1. Replace heel loop.
2. Reverse the disassembly procedures.
NOTE: When securing the heel loop to the
footrest assembly, tighten mounting screw
until the spacer is secure.
FIGURE 4.8 Composite/Articulating
Footplate Heel Loop Replacement
Installing/Removing Elevating Legrests
NOTE: For this procedure, refer to FIGURE 4.9 on page 36.
Installing
1. Place elevating legrest on the outside of the wheelchair and insert mounting pin into
the mounting tube.
2. Rotate elevating legrest toward the inside of the wheelchair until it locks in place.
NOTE: The calfpad of the legrest will be on the inside of the wheelchair when locked in place.
3. Repeat STEPS 1-3 for the other elevating legrest assembly.
Heel
Loop
Philips
Screw
Swingaway Footrest Assembly
Locknuts
Spacer
Hex Screw and
Coved Spacer
Lower Footrest
Assembly
COMPOSITE FOOTPLATE
Heel
Loop
Spacer
Washer
Philips
Screw
ARTICULATING
FOOTPLATE