Atm2 ds3 iq pic (m7i router) – Juniper Networks M7I User Manual

Page 16

Advertising
background image

ATM2 DS3 IQ PIC (M7i Router)

•

Junos OS Release 6.1 and later

Software release

•

Four DS3 ports

•

Power requirement: 0.41 A @ 48 V (20.0 W)

•

Intelligent queuing (IQ) PICs support fine-grained queuing per logical interface.

•

ATM standards compliant

Description

•

16-MB SDRAM memory for ATM segmentation and reassembly (SAR)

•

ATM switch ID

•

Configurable framing options:

•

C-bit with ATM direct mapping

•

C-bit with Physical Layer Convergence Protocol (PLCP) framing (default)

•

M23 ATM direct mapping

•

M23 with PLCP framing

•

Internal and loop timing

Hardware features

•

Per-virtual circuit (VC) and per-virtual path (VP) traffic shaping

•

Unspecified bit rate (UBR) traffic shaping

•

Fine-grained variable bit rate (VBR) traffic shaping

•

Circuit cross-connect (CCC)

•

ATM Inverse Address Resolution Protocol (ARP), which enables routers to automatically learn
the IP address of the router on the far end of an ATM permanent virtual circuit (PVC)

•

Simple Network Management Protocol (SNMP):

•

Management Information Base (MIB) 2 (RFC 1213)

•

ATM MIB (RFC 1695)

•

SONET MIB

•

AAL5 encapsulations:

•

ATM-VC-MUX

•

ATM-NLPID

•

ATM-Cisco-LLPID

•

ATM-SNAP

•

ATM-CCC-VC-MUX

Software features

Coaxial:

•

10 ft (3.05 m) posilock SMB to BNC (provided)

•

Four pairs of Rx and Tx coaxial cables

Cables and connectors

Copyright © 2010, Juniper Networks, Inc.

16

M7i Multiservice Edge Router PIC Guide

Advertising