Juniper Networks M7I User Manual

Page 54

Advertising
background image

•

Quality of service (QoS) per channel: weighted round-robin (WRR), random early detection
(RED), weighted random early detection (WRED)

•

SNMP: T1 MIB and DS0 MIB

•

Dynamic, arbitrary channel configuration

•

Full bit error rate test (BERT) patterns at T1 and DS0 levels

•

Encapsulations:

•

High-Level Data Link Control (HDLC)

•

Frame Relay

•

Circuit cross-connect (CCC)

•

Translational cross-connect (TCC)

•

Point-to-Point Protocol (PPP)

Software features

•

120-ohm RJ-48C connector (female)

Cables and connectors

One tricolor per port:

•

Off—Not enabled

•

Green—Online with no alarms or failures

•

Yellow—Online with alarms for remote failures

•

Red—Active with a local alarm; router has detected a failure

LEDs

•

Alarm indication signal (AIS)

•

Remote defect indication (RDI)

•

Loss of frame (LOF)

•

Loss of signal (LOS)

•

Bipolar violation (BPV)

•

Excessive zero (EXZ)

•

Line code violation (LCV)

•

Error seconds (ES)

•

Severely errored seconds (SES)

•

Severely errored frames (SEF)

•

Bit error event (BEE)

Alarms, errors, and
events

•

Layer 2 per-queue and per-channel packet and byte counters

•

24–hour history or error counter updated at 15–minute intervals

Instrumentation
(counters)

Related

Documentation

M7i PICs Description on page 3

•

•

M7i PICs Supported on page 4

•

M7i PIC/CFEB Compatibility on page 11

Copyright © 2010, Juniper Networks, Inc.

54

M7i Multiservice Edge Router PIC Guide

Advertising