Chapter 15 – Juniper Networks SRX 210 User Manual
Page 101
CHAPTER 15
Performing Initial Software Configuration
on the SRX210 Services Gateway
This chapter includes the following topics:
•
SRX210 Services Gateway Software Configuration Overview on page 85
•
Performing Initial Software Configuration on the SRX210 Services Gateway Using the
CLI on page 89
•
•
SRX210 Services Gateway Secure Web Access Overview on page 95
SRX210 Services Gateway Software Configuration Overview
This topic includes the following sections:
•
Preparing the SRX210 Services Gateway for Configuration on page 85
•
Understanding the Factory-Default Configuration on page 86
•
Understanding Built-In Ethernet Ports and Initial Configuration on page 86
•
Mapping the Chassis Cluster Ports on page 87
•
Understanding Management Access on page 88
Preparing the SRX210 Services Gateway for Configuration
The services gateway is shipped with the Juniper Networks Junos operating system (Junos
OS) preinstalled and ready to be configured when the device is powered on.
You can perform the initial software configuration of the services gateway by using the
browser-based setup wizard or by using the command-line interface (CLI).
Before configuring the device, gather the configuration information required to deploy
the device in your network. At minimum, the setup wizard requires the following
information:
•
Device name to be used on the network
•
Password for the root user
85
Copyright © 2013, Juniper Networks, Inc.