Juniper Networks SRX 210 - Manual (Page 93)

CHAPTER 14
Connecting the SRX210 Services Gateway
to Management Devices
This chapter includes the following topics:
• Connecting an SRX210 Services Gateway to the J-Web Interface on page 77
• Connecting an SRX210 Services Gateway to the CLI Locally on page 79
• Connecting an SRX210 Services Gateway to the CLI Remotely on page 80
• Connecting the Modem at the SRX210 Services Gateway End on page 81
• Connecting the Modem to the Console Port on the SRX210 Services Gateway on page 82
• Connecting to the CLI at the User End for the SRX210 Services Gateway on page 83
Connecting an SRX210 Services Gateway to the J-Web Interface
If you plan to use the setup wizard to configure the SRX210 Services Gateway, you must
connect your management device (such as a laptop or desktop computer) to one of the
built-in Ethernet ports 0/1 through 0/7 as shown in
Figure 24 on page 78 . Do not use
built-in Ethernet port 0/0.
NOTE: To access the J-Web interface, your management device requires a
supported browser: either Microsoft Internet Explorer version 7.0 or Mozilla
Firefox version 3.x.
77 Copyright © 2013, Juniper Networks, Inc.