Juniper Networks SRX 210 - Manual (Page 42)

Table 12: 3G ExpressCard Physical Specifications (continued)
Value Specification
• 3.3 V (primary source)
• 1.5 V (secondary source)
Voltage supply
Related
Documentation
SRX210 Services Gateway 3G ExpressCard Basic CLI Commands on page 27 •
• Installing the 3G ExpressCard in the SRX210 Services Gateway ExpressCard Slot on
page 26
• SRX210 Services Gateway Front Panel and Back Panel Views (Low Memory, High
Memory, and PoE Versions) on page 9
Installing the 3G ExpressCard in the SRX210 Services Gateway ExpressCard Slot
TIP: Placing the SRX210 Services Gateway on a flat, level surface, with the
Juniper Networks logo facing up, will make it easier to align and insert the 3G
ExpressCard in the ExpressCard slot.
CAUTION: 3G ExpressCard is not hot-swappable on the SRX210 Services
Gateway.
To install the 3G ExpressCard in the ExpressCard slot on the SRX210 Services Gateway:
1. Align the 3G ExpressCard as follows:
• Ensure that the 3G ExpressCard is parallel with the surface on which the SRX210
Services Gateway is placed.
• Ensure that the center of the 3G ExpressCard is aligned with the center of the
ExpressCard slot on the SRX210 Services Gateway.
2. Study Figure 11 on page 27 , which shows installation of the 3G ExpressCard on the
SRX210 Services Gateway.
Copyright © 2013, Juniper Networks, Inc. 26
SRX210 Services Gateway Hardware Guide