JVC HR-IP820U - Manual (Page 21)

21
To reset the tape counter to zero.
1 Press C. RESET.
Ⅲ Pressing DISPLAY repeatedly changes the VCR's
displayed indication. (Counter reading [ Channel* [
Clock time).
*Channel is not displayed during playback.
Counter Reset
To return to tape position zero.
During Playback...
1 Press C. RESET at a point you wish to locate later.
Ⅲ The counter will read "0
H 00 M 00 S ".
2 Press C. MEMORY.
Ⅲ
Counter Memory mark is displayed.
3 When you wish to return to that point, press STOP and then
press REW.
Ⅲ The tape will rewind and stop at about "0
H 00 M 00 S "
automatically.
4 To cancel the Counter Memory mode, press C. MEMORY.
Counter Memory
You can "tell" the VCR what to do immediately after rewinding.
During Stop:
For automatic start of playback after the tape is rewound...
1 Press REW.
2 Press PLAY within 2 seconds.
For automatic power off after the tape is rewound...
1 Press REW.
2 Press POWER within 2 seconds.
For automatic timer standby after the tape is rewound...
1 Press REW.
2 Press TIMER within 2 seconds.
Ⅲ To do the above using the VCR's controls:
During Stop, turn the Shuttle all the way to the left and
release it instead of pressing REW, and then press PLAY or
POWER within 2 seconds.
Ⅲ If you want the "next function" to automatically start when
the counter reads "0 H 00 M 00 S " (instead of at the beginning
of the tape), press C. MEMORY so that the counter
memory "M" mark appears on the VCR display panel
before pressing REW or FF.
Next-Function Memory
POWER Shuttle ring
+
– 00 00 00 00 00 00 00 00 00 00 0
00 00 00 00 00 00 00 00 00 00 0
PLAY
1 2 3
4 5 6
7 8 9
0 C.RESET
DISPLAY
POWER
TIMER
PLAY
C.MEMORY
REW
STOP
HR-IP820U-EN-1 97.5.20 5:25 PM Page 21