JVC HR-IP820U - Manual (Page 8)

8
Setting Up Your VCR
Making the right connections
It's essential that your VCR be properly hooked up for proper results. Follow these steps carefully. THESE STEPS MUST BE COMPLETED
BEFORE ANY VCR OPERATION CAN BE PERFORMED.
With a standard RF connection,
the VCR sends picture and sound
signals through the connecting
cable to your TV on channel 3 or
4. The VCR's switch is pre-set to
CH3 prior to shipment. Set this
switch to CH4 in areas where
channel 3 is used for broadcasting.
Back of VCR NOTES:
Ⅲ To operate the VCR with your TV using an RF
connection, it is always necessary to set your TV's
channel to the one you set the VCR to in this step.
Ⅲ Even if your TV is connected using AV input
connectors, it is necessary to also connect your VCR
and TV using the RF cable if you ever wish to watch
a program while recording another (
੬
p. 23).
CH3 CH4
RF OUT
CABLE
BOX
SPECIAL
FUNCTION
LINK
/OUT
RF CONNECTION
For TV sets without AV input terminals:
1 Disconnect the TV antenna from the TV.
2 Connect the TV antenna to the VCR's ANT. IN.
3 Connect the VCR's RF OUT to the TV's antenna terminal
using the provided RF cable.
Back of VCR
ANT. IN
(Antenna or
Cable input)
RF OUT
RF Cable
(provided)
75 ohm
terminal
See the "Basic Guide For VCR Connections" sheet
enclosed with this instruction manual for more
information and other possible connections.
RECORDER-TO-TV CONNECTION A
AUDIO OUT VIDEO OUT
Audio/Video Cable (provided)
AUDIO IN
VIDEO IN
AV CONNECTION
For TV sets with AV input terminals:
1 Connect the antenna, VCR and TV as per "RF CONNECTION".
2 Connect the VCR's AUDIO OUT and VIDEO OUT to the TV's
AV-IN terminals using the provided AV cable.
Flat Feeder
Coaxial Cable
Matching Transformer
AC Power
Cord
AC Outlet
Antenna or Cable
SELECT VCR CHANNEL ( 3 OR 4) B
HR-IP820U-EN-1 97.5.20 5:25 PM Page 8