JVC HR-IP820U - Manual (Page 22)

22
Playback (cont'd)
SET
Your VCR is compatible with JVC's AV COMPU LINK
components which include amplifiers (or receivers) and televisions.
PREPARATION
1 Connect your VCR to an AV COMPU LINK amplifier and/or
an AV COMPU LINK television as illustrated.
2 Press MENU, SET, and
SELECT as many times as
necessary to access the
SPECIAL FUNCTION screen.
(
੬
p. 7)
3 Press SET to choose "AV
COMPU-LINK".
4 Press MENU as many times as
necessary to exit.
OPERATION
AV COMPU LINK video playback is as easy as this:
Ⅲ Simply load a cassette in your VCR and press PLAY. (If the
cassette's safety tab has been removed, it is not necessary to
press play.) The TV (and amplifier) turn on automatically and
the TV's mode is automatically set to VIDEO; you're ready to
watch!
Ⅲ Connection varies according to the type of TV. Please read
your TV's instruction manual when making TV connection.
AV COMPU LINK Playback
Your VCR
VIDEO IN
AUDIO
IN
AUDIO OUT
VIDEO OUT
Mini-plug Cable
(provided)
AV COMPU LINK
Television
SPECIAL FUNCTION
R.A.EDIT/PAUSE
Ł AV COMPU-LINK
PRESS (SET +/–) FOR CHOICE
PRESS (MENU) TO END
Example
PAUSE/SPECIAL
FUNCTION
AV COMPU LINK II
(VCR ONLY)
MENU
SELECT
POWER
PLAY
1 2 3
4 5 6
7 8 9
0
Digit key 1
Digit key 2
The remote control is capable of controlling two JVC VCRs
independently; one set to respond to your remote control's A code
control signals and another set to respond to B code control
signals. The remote control is preset to send A code signals
because your VCR is initially set to respond to A code signals.
You can easily modify your VCR to respond to B code signals.
1 Hold down the remote control's STOP button.
Press the digit key "2". Release the STOP button.
2 Unplug the VCR's power cord from the AC outlet and then
plug it back in again. Do not use other remote controls at this
stage.
3 Turn the VCR power on using the remote control's POWER
button. The VCR will now respond only to B code signals.
Ⅲ To set the VCR back to respond to A code signals, repeat
the same procedure as shown above except pressing Digit
key "1" instead of "2" in step 2.
Ⅲ If you want to operate two JVC VCRs independently which
are set to respond to either A or B code signals, set the
remote control to the code corresponding to the VCR you
want to operate:
To operate a VCR set to A code, while holding down the
remote control's STOP button, press the Digit key "1".
To operate a VCR set to B code, while holding down the
remote control's STOP button, press the Digit key "2".
To control two JVC VCRs
STOP
HR-IP820U-EN-1 97.5.20 5:26 PM Page 22