Basic recording, Load a cassette, Choose a programme – JVC HM-DR10000EU User Manual
Page 22: Set tape speed, Start recording, Pause/resume recording, Stop recording, Recording, D-vhs recording
22
EN
TV signals being received by the recorder’s built-in tuner can be
recorded onto a video tape. You can "capture" a TV programme
using your video recorder.
RECORDING
Basic
Recording
LOAD A CASSETTE
1
Insert a D-VHS cassette with the record safety tab intact.
● The recorder power comes on automatically and the
counter is reset to 0:00:00.
● The STD (or LS3) indicator lights and the D-VHS
recording mode is selected automatically.
CHOOSE A PROGRAMME
2
Press TV PROG +/– or the NUMBER keys to select the
channel you wish to record.
● The TV PROG dial can also be used to select a
channel.
SET TAPE SPEED
3
Press STD/LS3 (
). Check the STD or LS3 indicator
to confirm the selected tape speed.
START RECORDING
4
Press and hold RECORD and press PLAY on the remote
control, or press RECORD on the recorder.
PAUSE/RESUME
RECORDING
5
Press PAUSE. Press PLAY to resume recording.
STOP RECORDING
6
Press STOP. Then press EJECT to remove the cassette.
If "DIRECT REC" is set to "ON", the programme
that appears on the TV screen will be recorded
(
੬
pg. 13).
1
2
3
4
5
6
7
8
9
2
1
2
3
0
3
4
4
NUMBER
TV PROG
PLAY
PAUSE
ST
O
P
RECORD
STD/LS3 (SP/LP)
Turn on the TV and select the AV mode.
D-VHS
TV PROG
STD/LS3 (SP/LP)
PLAY
RECORD
PAUSE
STOP
EJECT
TV PROG
STD indicator
LS3 indicator
D-VHS Recording
NOTE:
To record in the S-VHS or VHS mode on a D-VHS cassette,
press D-VHS so that the STD (or LS3) indicator goes off (
੬
pg.
26).