Load a cassette, Choose a programme, Set tape speed – JVC HM-DR10000EU User Manual
Page 23: Start recording, Pause/resume recording, Stop recording, S-vhs/vhs recording
EN
23
LOAD A CASSETTE
1
Insert a cassette with the record safety tab intact.
● The counter is reset to 0:00:00 and the recorder
power comes on automatically.
CHOOSE A PROGRAMME
2
Press TV PROG +/– or the NUMBER keys to select the
channel you wish to record.
● The TV PROG dial can also be used to select a
channel.
SET TAPE SPEED
3
Press SP/LP (
). Check the SP/LP indicator on the
front display panel to confirm the selected tape speed.
START RECORDING
4
Press and hold RECORD and press PLAY on the remote
control, or press RECORD on the recorder.
PAUSE/RESUME
RECORDING
5
Press PAUSE. Press PLAY to resume recording.
STOP RECORDING
6
Press STOP. Then press EJECT to remove the cassette.
B.E.S.T. takes place at the beginning of both the
first SP and the first LP recording after inserting the
cassette.
If "DIRECT REC" is set to "ON", the programme
that appears on the TV screen will be recorded
(
੬
pg. 13).
S-VHS/VHS Recording
Compatibility Of Cassettes And
Recording Mode
Cassette
Recording Mode
D-VHS
S-VHS
VHS
D-VHS
Yes
Yes
Yes
S-VHS
No
Yes
Yes
VHS
No
No
Yes
NOTES:
●
The D-VHS (MTP), S-VHS and VHS mode recordings are
possible with this recorder.
●
To record in the D-VHS mode, use a D-VHS cassette.
●
To record in the S-VHS mode, you can use a S-VHS or D-
VHS cassette.
●
To record in the VHS mode, you can use a VHS, S-VHS or
D-VHS cassette.
● To prevent accidental recording on a recorded cassette,
remove its safety tab. To record on it later, cover the hole
with adhesive tape.
Record safety tab
Accidental erasure prevention