JVC HM-DR10000EU - Manual (Page 25)

EN
25
Elapsed Recording Time
Indication
You can check the exact time of a recording.
SET COUNTER DISPLAY
1
Press – –:– – (or DISPLAY) until a counter reading
appears on the display panel.
RESET COUNTER
2
Press 0000 (or COUNTER RESET) before starting
recording or playback.
● The counter is reset to "0:00:00" and shows the exact
elapsed time as the tape runs.
Tape Remaining Time
DISPLAY REMAINING TIME
1
Press – –:– – (or DISPLAY) until the time remaining on
the tape appears.
● The display panel shows the tape remaining time
with " " displayed.
● By pressing the – –:– – (or DISPLAY) button, you can
change the display to show the counter reading,
channel position*, clock time or tape remaining time.
* channel position is not displayed during playback.
NOTE:
Depending on the type of tape used, there may be times when
the tape remaining time reading may not appear right away, or
is not correct. "– –:– –" may sometimes appear, or the display
may blink on occasion.
COUNTER RESET
DISPLAY
1 2 3
4 5 6
7 8 9
1
2
1
2
3
– –:– –
0
3
4
4
0000
– –:– –