JVC HM-DR10000EU - Manual (Page 55)

EN
55
The Synchro Editing function synchronizes the start of the
playback and recording operations when starting an edit
operation using a camcorder with LANC connector and your
video recorder.
Synchro Editing
(S-VHS/VHS Mode
Only) MAKE CONNECTIONS
1
Connect your recorder to camcorder (
੬
pg. 50), and
connect your recorder's SYNCHRO EDIT connector to
the camcorder's LANC connector.
SET RECORDING MODE
2
Set the appropriate recording mode (S-VHS or VHS)
(
੬
pg. 23).
SET RECORDER'S INPUT
MODE
3
Set the appropriate input mode, depending on the
connectors being used in step 1.
SET EDIT MODE
4
See "Picture Control" on page 49.
LOCATE START POINT
5
Start playback of the tape in the camcorder, and pause
playback when you find the point where you want to
start editing. Press and hold PAUSE and press RECORD
on your recorder so that the recorder enters the Record-
Pause Mode.
START SYNCHRO EDITING
6
Press SYNCHRO EDIT.
PAUSE SYNCHRO EDITING
7
Press SYNCHRO EDIT again.
● Repeat steps 5 – 7 as necessary.
NOTES:
● The Synchro Editing function is impossible with the connec-
tion using DV connector.
● The Synchro Editing function may not work with the initial
part of a camcorder tape.
● The Synchro Editing function cannot be used when using the
JLIP function. (Pressing SYNCHRO EDIT cancels the JLIP
function.)
● The Synchro Editing function may not work properly with
some type of camcorder.
● When you select EDIT to dub tapes in step 4, be sure to select
AUTO (or NORM when B.E.S.T. is set to OFF) after you finish
dubbing the tapes.
LANC Cable
(not provided)
Camcorder
Recorder
SYNCHRO EDIT
connector
Player
To LANC connector
PAUSE
RECORD
SYNCHRO EDIT