JVC GR-DVM55 - Manual (Page 11)

EN
11
ON SCREEN OFF
ON
DISPLAY
DATE / TIME 1 . 1 . 00
0 : 00
4
RETURN
REC MODE
WIDE MODE
OFF
AGC
40X
SP
ZOOM
DIS
GAIN UP
TO DATE / TIME MENU
TO SYSTEM MENU
4
END
ON
OFF
PLA
Y
A
M
5S
Date/Time Settings
Date and time will automatically be recorded on tape at all times. It is your choice to display it or not during
playback (
੬
pg. 53).
1 SELECT OPERATION MODE
Set the Power Dial to “ M ” while pressing down
the lock button located on the dial, and open
the LCD monitor fully.
•The power lamp comes on and the
camcorder is turned on.
•The LCD monitor can be tilted upward up to
180 degrees and downward up to 90 degrees.
2 ACCESS RECORDING MENU
Press MENU. The Recording Menu appears.
3 ACCESS DATE/TIME MENU
Move the pointer and highlight bar to “TO
DATE/TIME MENU” by rotating the Select Dial.
Press the Select Dial and the Date/Time Menu
appears.
4 INPUT DATE AND TIME
Move the pointer and highlight bar to “DATE/
TIME” by rotating the Select Dial. Press the
Select Dial and “day” is highlighted and begins
blinking.
Rotating the Select Dial, input the day. Press
the Select Dial. Repeat the procedure to input
the month, year, hour and minute.
•Press the Select Dial twice when the pointer
and highlight bar are set to “RETURN” to exit.
LCD monitor
MENU button
Recording Menu
Date/Time Menu
Lock button
Power Dial
Power lamp
Select Dial
Regarding Built-in Rechargeable Battery
To store the date/time in memory, a rechargeable
clock lithium battery is integrated in the camcorder.
While the camcorder is connected to an AC outlet
using the AC Charger Station, or while the battery
pack installed in the camcorder continues to supply
power to the camcorder, the clock lithium battery is
always charged. However, if the camcorder is not
used for approx. 3 months, the clock lithium battery
will become discharged and the date/time stored in
memory will be lost. When this occurs, first connect
the camcorder to an AC outlet using the AC Charger
Station etc. for over 24 hours to charge the clock
lithium battery. Then perform the date/time setting
before using the camcorder.
It is also possible to use the camcorder without the
date/time setting.
NOTE:
If you don’t exit the Date/Time Menu, the clock
display will not move but the camcorder’s internal
clock continues to operate. Once you close the
menu, the date and time begin operation from the
current date and time, with no delay or loss.