JVC GR-DVM55 - Manual (Page 74)

74
EN
SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION
36. •The LCD monitor or the
viewfinder is made with
high-precision technology.
However, black spots or
bright spots of light (red,
green or blue) may appear
constantly on the LCD
monitor or the viewfinder.
These spots are not recorded
on the tape. This is not due
to any defect of the unit.
(Effective dots: more than
99.99 %)
37. •During playback of the
unrecorded portion, High-
speed Search and still
playback, LCD monitor
indications appear distorted.
This is not a defect.
38.
————
39. •A malfunction of some kind
has occurred. In this case
the camcorder’s functions
become unusable.
40. •The temperature of the
battery is extremely high/low.
•Charging is difficult in places
subject to extremely high/
low temperatures.
41. •This occurs when recording
in the LP mode is not
available. After the indicator
blinks, the recording mode
switches to “SP” and
recording goes on.
42. •The viewfinder is pulled out.
•The LCD monitor’s
brightness setting is too dark.
43. •This is not a malfunction.
36.
————
37.
————
38. • Check the section of the
manual that explains LCD
monitor/viewfinder
indications
(
੬
pgs. 79 – 81).
39. • Remove the power supply
(battery pack, etc.) and
press RESET button, and
wait a few minutes for the
indication to clear. When it
does, you can resume using
the camcorder.
If the indication remains
even though you repeat the
above two or three times,
please consult your nearest
JVC dealer.
40. • To protect the battery, it is
recommended to charge it
in places with a temperature
of 10°C to 30°C (
੬
pg. 9).
41.
————
42. • Push the viewfinder back in.
• Adjust the brightness of the
LCD monitor (
੬
pg. 22).
• If the monitor is tilted
upward 180 degrees, open
the monitor fully
(
੬
pg. 23).
43. • By recording with Digital
Image Stabilizer set to “ON”
(
੬
pg. 32) this can be
avoided.
36. Coloured bright spots
appear all over the LCD
monitor or the viewfinder.
37. The LCD monitor
indications are distorted.
38. An unusual mark appears
in the LCD monitor or the
viewfinder.
39. An error indication
(E01 — E06) appears in
the LCD monitor or the
viewfinder.
40. The charge indicator on
the AC Charger Station
does not light.
41. The recording mode
indicator “LP” blinks on
the LCD monitor or the
viewfinder.
42. Picture does not appear
on the LCD monitor.
43. When the image is printed
from the printer, a black
bar appears at the bottom
of the screen.
TROUBLESHOOTING (Cont.)