John Deere OMPC20964 - Manual (Page 105)

Original GreenStar Display—RTK
OUO6050,0002351 –19–19NOV06–1/1
INFO Pages, Base Station
PC9737
–UN–19NOV06
Quick Survey
PC9738
–UN–19NOV06
Absolute Survey
A—RTK Base Station Data C—Distance E—Signal Level G—Software Version
Status Direction Data Received Serial Number
B—Satellite Corrections D—Base Battery F—Radio Connection
Location Number
Radio Data
Screen: INFO - GPS - PAGE 5
This screen allows operator to view:
• Status
– OK - Base Station is transmitting correction.
– No Stored Base - 24 hour self survey is required
for current location.
– Initializing - Receiver is initializing radio, acquiring
GPS signal.
– Self Survey - 24 hour self survey in progress.
• Sat Corrections - Indicates number of GPS
satellites for which base station is transmitting
correction.
• Distance - Difference between base station location
(known position) and location indicated by
uncorrected GPS.
• Direction - Direction from base station location
(known position) to location indicated by uncorrected
GPS.
• Base Battery (volts) - Base Station voltage.
• Signal Level - Level of signal that is detected at
radio. The signal level will range from 0 to 100 (-180
dBm to -80 dBm or above). Press E button to
refresh signal level.
NOTE: For Data Received (%): Value less than 100 %
indicates an obstruction between base station
radio and vehicle radio.
If percent of received correction is 0, and
signal level is high, check for potential radio
interference sources such as two-way radios,
radio towers, etc.
• Data Received (%) - Percent of received correction
to base station from vehicle.
• Radio Connection - Indicates source of correction.
If there is no connection, this will toggle between
base and repeater.
• SW - Version of radio software
• SN - Serial number of radio connected to receiver.
30-17
121907
PN=105