Hours on after shutdown, Tcm calibration – John Deere OMPC20964 User Manual
Page 16
GS2 Display—StarFire iTC
OUO6050,0002244
–19–14NOV06–1/1
Hours On After Shutdown
Defines how long receiver remains powered up after
ignition is turned off (0, 3, 6, 12, 24 hours). If ignition is
turned on within number of hours defined, receiver will
re-establish full SF1 or SF2 accuracy within a few
seconds (assuming it had SF1 or SF2 when ignition
was turned off).
Define desired number of hours by selecting
drop-down box.
OUO6050,0002245
–19–14NOV06–1/4
TCM Calibration
PC8278
–UN–22JUN04
Floating Front Axle Vehicles
PC8277
–UN–01MAY06
Fixed-Axis Wheels Or Tracks Vehicles
A—Rear Axle
B—Vehicle Pivot Point
TCM can be toggled ON or OFF by selecting TOGGLE
button. When TCM is turned off, StarFire GPS
message will not be corrected for vehicle dynamics or
side slopes. TCM will default to ON when cycling
power.
NOTE: TCM must be turned on for AutoTrac to
activate.
TCM must be calibrated so receiver can determine
zero degree roll angle.
Continued on next page
15-8
121907
PN=16