John Deere OMPC20964 - Manual (Page 112)

RTK Base Station Setup
OUO6050,0002356 –19–19NOV06–1/1
Attaching RTK Harness
PC8570
–UN–14JUL05
PC8568
–UN–14JUL05
PC8571
–UN–14JUL05
PC8569
–UN–14JUL05
A—Rod B—Grounding Wire C—Collar D—Screw
CAUTION: Avoid serious injury or death to
you or others. Contact your local utility
companies to determine the location of gas,
electric, or water lines. Placement of
grounding rod must be a safe distance away
from pipelines and cables.
IMPORTANT: Carefully choose location of rod so
that it is away from paths where it
could damage equipment or be
damaged by equipment.
DO NOT route RTK Extension
harness along any other power
sources. Keep harness at least 2m (6
ft) away from any other AC power
lines.
1. Attach harness between radio and receiver.
2. Carefully determine placement of rod (A) a safe
distance away from pipelines and cables. Drive into
ground leaving one end above surface.
3. Route grounding wire (B) from harness to rod.
Grounding wire may be extended if necessary to
reach rod.
4. Remove insulation from end of grounding wire.
5. Place collar (C) over end of rod.
6. Place grounding wire between rod and screw (D).
7. Tighten screw.
8. Restrain harness to supporting structures as
necessary to keep them away from equipment,
damage, and to reduce wire strain.
35-5
121907
PN=112