JVC XU-301BK - Manual (Page 22)

20
English
Listening to MDs
Playing all tracks
1 Place the MD in position.
• Place the MD with its label side facing up. When it is inserted in the direction shown by the
arrow, the power turns on and the MD is automatically drawn inside.
• When “MD” is already set as the function, the track numbers and play time are displayed after the
“TOC READING” display.
• The MD display appears to indicate that an MD has been inserted.
2 Set the function to “MD.”
3 Press the 6 button. \ Play now starts.
• MD play starts from track No.1.
• The numbers of the tracks which have been played are cleared from the music calendar.
Stopping MD play —————————————————————
• Stopping play at any time
• When the button on the left is pressed, the track number and play time appear on the display.
When all the tracks on an MD have been played through, play will stop automatically.
• Stopping play temporarily
• When the button on the left is pressed, 8 is displayed. When it is pressed again, play is resumed
from the place where it was stopped.
Operate by following the steps
below in numerical order.
MD
Lamp lights.
Music calendar
The display changes to track No.1 after 3 seconds.
Place the MD with its label side facing
up, and insert it in the direction of the
‹or ] mark.
XU-301 MD-CD COMBINATION DECK
REC PAUSE REC START REC DIGITAL CD
REC SOURCE SELECTOR
LINE MIC STOP
MIXING CANCEL
CD
MD
MIC
MAX MIN
PHONES
MIX BALANCE REC LEVEL
CD
LINE LINE
MIC
PLAY MODE /CHARA DISPLAY TITLE EDIT 32kHz 44.1kHz DIGITAL INPUT 48kHz
LISTENING
SKIP
1st TRACK REC
TIMER /CLOCK STANDBY
CD REC
SET
2 CD
CD 3
1 CD PLAY & EXCHANGE
3 - CD
NORMAL SPEED
CD PITCH CONTROL
POWER
EDIT
SAMPLING RATE CONVERTER
3 1 2
L
R 40 30 15 10 20 6 3 0
MD
L
R 40 30 15 10 20 6 3 0
MD
06/p20-23 (E) 4/1/98, 4:43 PM 20