JVC XU-301BK - Manual (Page 34)

32
English
When there is not much recording time left on the MD, the tracks which can be recorded are auto-
matically searched (on all the CDs).
When up to 32 tracks are programmed, recording starts from program 1.
The same applies when the programming for all the CDs is completed.
• When MD recording is completed
After “UTOC WRITING” is displayed, operation stops automatically. It also stops automatically
when play of the last CD finishes.
• To stop the recording at any time
Press the 7 (stop) button.
The recording mode is released after “UTOC WRITING” is displayed.
Track marking ———————————————————————
The mode can be switched from AUTO to MANUAL or vice versa by pressing the TRACK MARKING
button on the remote control.
• When AUTO has been set:
• Whenever playback advances from one track to another during digital recording, the track number
at the MD side is automatically incremented by 1.
• Whenever no sound at the playback side continues for 3 or more seconds during analog recording,
the track number at the MD side is automatically incremented by 1.
• When MANUAL has been set:
• The track number at the MD side remains unchanged whether digital recording or analog
recording is performed.
• The track number at the MD side is automatically incremented by 1 by pressing the SET button
on the remote control or unit at the desirable location.
There is no need to adjust the recording level (for a digital recording).
Up to 32 tracks can be included in the programming. The same track cannot be programmed twice.
If a CD has no tracks which are to be recorded, remove it from the CD tray.
Upon completion of the MD recording, “UTOC WRITING” is displayed. Operating any button while
this message is displayed may render the MD unusable.
Always wait for “UTOC WRITING” to be cleared before proceeding with the next operation.
Mixing Recording
1 Insert the recording MD.
• Insert the MD with its label side facing up.
2 Establish the rec pause mode.
• The remaining recording time on the MD and MD
REC
appear in the display window.
All the REC SOURCE SELECTOR lamps flash.
Lamp lights.
REC
PAUSE
REC
START
• If a track which can be
recorded is found, its
play time is displayed.
Press the LISTENING
EDIT button to
program the track.
• If no track which can
be recorded is found,
recording will start
from program 1.
XU-301 MD-CD COMBINATION DECK
REC PAUSE REC START REC DIGITAL CD
REC SOURCE SELECTOR
LINE MIC STOP
MIXING CANCEL
CD
MD
MIC
MAX MIN
PHONES
MIX BALANCE REC LEVEL
CD
LINE LINE
MIC
PLAY MODE /CHARA DISPLAY TITLE EDIT 32kHz 44.1kHz DIGITAL INPUT 48kHz
LISTENING
SKIP
1st TRACK REC
TIMER /CLOCK STANDBY
CD REC
SET
2 CD
CD 3
1 CD PLAY & EXCHANGE
3 - CD
NORMAL SPEED
CD PITCH CONTROL
POWER
EDIT
2 4 1 6 3
SAMPLING RATE CONVERTER
07/p24-33 (E) 4/1/98, 4:44 PM 32