JVC XU-301BK - Manual (Page 30)

28
English
Manual Recording
1 Insert the recording MD.
• Insert the MD with its label side facing up.
2 Establish the rec pause mode.
• The remaining recording time on the MD and MD
REC
appear in the display window.
The record mode indicator lamp flashes.
• All the REC SOURCE SELECTOR lamps flash when none of the REC SOURCE SELECTOR
buttons have been selected.
3 Select (one of) the recording sources.
• DIGITAL : For recording the sound of a unit which has been connected to the OPTICAL IN
connector (digital input)
• CD : For recording the CDs inserted into CD1, CD2 and/or CD3 (when the CD pitch
control is set to OFF for the digital input)
Note: Analog recording is performed for CD+LINE or CD+MIC mixing even
when the CD pitch control has been set to OFF.
• LINE : For recording the sound of a unit which has been connected to the LINE IN
connector (analog input)
• MIC : For recording the sound from a microphone which has been connected to the MIC
jack (analog input)
• If a source has already been selected, its corresponding lamp will light. The lamp of the selected
source stops flashing and lights. The other lamps go off.
4 When analog signals are supplied, adjust the recording level.
(The sound will be recorded with some distortion if the OVER display (red) lights continuously.)
5 Play the sound of the source to be recorded.
• If the CD1 button is pressed when CDs serve as the source, the tracks are recorded in the follow-
ing sequence:
CD1 = CD2 = CD3 .
6 Press the REC START button to start the recording.
• Press the TRACK MARKING button on the remote control to allocate track numbers during
recording.
• When MD recording is completed
After “UTOC WRITING” is displayed, operation stops automatically.
Press the REC STOP button to stop the recording at any time.
• DIGITAL INPUT lamps
These lamps light as follows in the rec pause or recording mode.
•
DIGITAL : 32 kHz–48 kHz lights depending on the sampling frequency of the recording
source.
• CD : 44.1 kHz lights
(When analog signals
are supplied)
Flashing
Lamp lights.
Flashing
MAX MIN
REC LEVEL
REC
PAUSE
REC
START
• Press the same button again
to clear the selection.
• Adjust the volume in such a way that the 0 dB display
is not exceeded when the loudest sound is supplied.
XU-301 MD-CD COMBINATION DECK
REC PAUSE REC START REC DIGITAL CD
REC SOURCE SELECTOR
LINE MIC STOP
MIXING CANCEL
CD
MD
MIC
MAX MIN
PHONES
MIX BALANCE REC LEVEL
CD
LINE LINE
MIC
PLAY MODE /CHARA DISPLAY TITLE EDIT 32kHz 44.1kHz DIGITAL INPUT 48kHz
LISTENING
SKIP
1st TRACK REC
TIMER /CLOCK STANDBY
CD REC
SET
2 CD
CD 3
1 CD PLAY & EXCHANGE
3 - CD
NORMAL SPEED
CD PITCH CONTROL
POWER
EDIT
2 3 1 4 6
SAMPLING RATE CONVERTER
DIGITAL CD
REC SOURCE SELECTOR
LINE MIC
MIXING
L
R
40 30 15 10 20 6 3 0
REC
PAUSE
REC
START
07/p24-33 (E) 4/1/98, 4:44 PM 28