JVC XU-301BK - Manual (Page 48)

46
English
• To ascertain the correct time
Use the time display on your TV screen or call the speaking clock.
• When a power failure has occurred or the power cord has been
disconnected
The time display is cleared, and the “ ” flashing display is returned. In a case like this,
re-set the time by previous steps 1 and 2. When the power cord is left disconnected for an extended
period of time, the time display returns to “
.”
• Setting the time while the power is ON
After the power has been turned on, press the TIMER/CLOCK button, select the present time display,
and set the time.
If the CANCEL button is pressed while setting the “minute” display, the flashing “hour” display is
restored. This function comes in handy for correcting the “hour” display.
Timer Operations
Timer Play (wake-up play)
1 Turn on the power.
• The selected function (“CD” at the time of purchase) is displayed.
2 Select the timer mode (DAILY TIMER or ONCE TIMER).
Operating examples
• Set DAILY TIMER for timer playback.
• Set ONCE TIMER for timer recording.
Operate by following the steps
below in numerical order.
Lamp goes out.
TIMER
/CLOCK
TIMER
/CLOCK
TIMER
/CLOCK
TIMER
/CLOCK DAILY TIMER
«
ONCE TIMER
«
Present Time : Select this display and set the time.
Function
display
»
\
• The mode changes each time
this button is pressed.
DAILY TIMER : The timer is activated every day.
«
ONCE TIMER : The timer is activated only once.
«
Present Time (“hour” display flashes.)
Function
display
»
\
XU-301 MD-CD COMBINATION DECK
REC PAUSE REC START REC DIGITAL CD
REC SOURCE SELECTOR
LINE MIC STOP
MIXING CANCEL
CD
MD
MIC
MAX MIN
PHONES
MIX BALANCE REC LEVEL
CD
LINE LINE
MIC
PLAY MODE /CHARA DISPLAY TITLE EDIT 32kHz 44.1kHz DIGITAL INPUT 48kHz
LISTENING
SKIP
1st TRACK REC
TIMER /CLOCK STANDBY
CD REC
SET
2 CD
CD 3
1 CD PLAY & EXCHANGE
3 - CD
NORMAL SPEED
CD PITCH CONTROL
POWER
EDIT
2 1
3
4 5 ·
SAMPLING RATE CONVERTER
STANDBY
POWER
STANDBY
POWER
09/p45-49 (E) 4/1/98, 5:09 PM 46